Skip to main content

Setting up your Jolt hardware

Use this hardware setup guide for Jolt including unboxing, assembling, and configuring your Jolt Print Station (JPS), tablet display, and Zebra printer connections.


Parts you will need

In the image below, you will see the items you will need for your JPS setup. Before getting started, clear the area where the hardware will be placed. If using multiple ZT111 printers, please ensure that you leave enough room (~5-6 in of clearance) between each printer to allow the side media door to open to change out a roll of labels or ribbon.
​

  1. Central JPS

  2. ZT111 printer

  3. 1 power cable for the central JPS and 1 per ZT111 printer

  4. 1 USB-B to USB-A cable per ZT111 printer

  5. Surge-protected power strip

  6. USB hub (if applicable)

  7. MG-T30 or MG-T60 weight scale (if applicable)

  8. Weight scale power cord (if applicable)

  9. Weight scale serial to USB-A cable (if applicable)

  10. Weight scale serial cable (if applicable)
    ​

Note: Items 9 and 10 should already be connected and secured together, as pictured below. If they are not, please contact Jolt Support for next steps


Instructions

  1. Place the central JPS, ZT111 printer(s), and weight scale in the designated area and make sure that all components are stable, secure and have enough space to properly function.

  2. On the rear-side of the ZT111 printer(s), attach one power cable and the square end of one USB-B to USB-A cable into the appropriate ports, as shown below. Repeat for any additional printers, if needed.
    ​

  3. On the right-hand side of the central JPS, attach one power cable into the appropriate port.
    ​

  4. If using a weight scale, flip the scale over to reveal the power and serial (looks like a phone jack) ports in the recessed section on the bottom. Plug the weight scale power cord and weight scale serial cable(s) into the appropriate ports.
    ​

  5. Locate the USB Hub. Plug the USB-A (male) ends from any of the ZT111 printers and/or weight scale into the open ports on the hub.
    ​

  6. Plug the single USB-A (male) connector from the USB hub into one of the USB-A (female) ports on the side of the central JPS unit near the power port.
    ​

    Note: The USB hub only supports up to 4 USB devices being plugged into it. If there are more than 4 devices present between ZT111 printers and weight scale, you may need either an additional USB hub, or you can plug a single excess cable into the second USB-A (female) port on the side of the central JPS unit.

  7. Plug all power cables (if applicable) from the central JPS unit, all ZT111 printers, and weight scale if applicable into a surge-protected power strip, and plug the power strip into a working outlet.

  8. Make sure everything powers on properly.

  9. The central JPS unit screen can be turned on by pressing and holding the power button for the tablet/screen for a few seconds, which can be found in a cutout on the right side of the stainless steel frame.
    ​

  10. The ZD410/ZD411 printer attached to the metal base of the central JPS unit can be turned on, if needed, by pressing and holding the power button on the top of the printer.

  11. The ZT111 printer can be turned on by pressing the switch on the rear side of the printer. Make sure the \"I\" side is pressed down toward the printer.
    ​

  12. The weight scale can be turned on by pressing and holding the red Zero | On/Off button on the front of the scale until the scale makes a beep.
    ​

Did this answer your question?