Ambient Sensor Installation

This tutorial will guide you through the process of installing an ambient sensor in your pharmacy environment.

1. Locate the box in your installation kit that is labeled "RX AMBIENT."
   
   
2. Inside the box, you will find the WIRELESS SENSOR and magnetic screen.
   • You must have a gateway that is installed and powered on for the sensor to work properly
     
     
3. Locate the NIST SENSOR in the installation kit (temperature and humidity sensors come separately but can be used concurrently in ports 1 and 2). Line up the arrow on port 1 with the arrow on the NIST sensor and carefully screw in the sensor so as not to damage the pins. 
   
   
4. Press the POWER BUTTON on the wireless sensor.
   • All three LED lights will flash quickly and then turn off
   • Within a few seconds, the green status light will flash rapidly for about 30 seconds
   • When the rapid flashing stops, this indicates that the wireless sensor is connected to the Gateway and has sent a reading
   • You should see the temperature on the magnetic screen update
     
     
5. To install the ambient sensor, locate a well-ventilated area at the top of the first drug bay at your pharmacy. 
   • The wireless sensor is magnetic and will adhere to metal shelving
   • If necessary, use velcro or double-sided tape to adhere the sensor to the drug bay
   • DO NOT place the sensor near a heating vent or near the drive-through window (the screen will adhere to the wireless node magnetically)
     
     
6. For a more secure connection, ensure the MAGNETS of the screen fit into the cradles on the front of the sensor. 
   
   
7. Alternatively, place the magnetic screen in an area of the pharmacy with the other screens for fridges and freezers. 
   • Moving the magnetic screen more than 50 feet from the sensor may result in a poor connection
   • You can discard the QR code and barcode stickers that were packed in the sensor's box
   • Wireless sensors will generate readings every 15 minutes
     
     
8. If a temperature threshold has been violated, the screen will read "ALARM" and you will hear an audible sound.
   • You can snooze the alarm by tapping the POWER BUTTON on the magnetic screen
   • There may be a slight delay, so you may still hear the audible alarm for a short period after the temperature has returned within range
   • The batteries in a wireless sensor can last up to 5 years (if a gateway loses power, the device will search for a connection constantly and battery performance may be reduced)
     
     
9. You can push your reading to the SmartSense Dashboard anytime by tapping the POWER BUTTON on the wireless sensor. 
   • SmartSense will monitor the device, and if there are any concerns, we will reach out to your store and troubleshoot with you