B2 Sensor Installation Guide
Use these instructions to add a SmartSense B2 Sensor to an existing SmartSense environment.
This tutorial focuses on adding a B2 Sensor to an existing environment. Please see Kitchen Self-Installation Guide or Grocery Self-Installation Guide for more complete installation instructions.
If your B2 Sensor has not been provisioned to your account, you will need to contact SmartSense support.
Installing the B2 Sensor
Your SmartSense B2 Sensor arrives powered off.
- To turn on your B2 Sensor, hold the button for approximately 3 seconds until the green LED begins to blink, then immediately release the button.
- The green LED will remain on for 5 seconds to indicate that it is powered on and broadcasting. Under normal operation, these are the only times the LED will illuminate. Once your B2 Sensor is powered on, it cannot be turned off.
- SmartSense recommends installing the sensor according to the FDA model food code guidance, placing it “in a location that is representative of the actual storage temperature of the unit” away from any compressors or fans.
- Use the included zip tie to mount the B2 Sensor. The zip tie should be threaded through the mounting loop at the top of the sensor and attached securely to a mounting point so that the sensor is hanging vertically and facing toward the door of your case.
- If a suitable mounting point does not exist, contact SmartSense for additional mounting options.
Verify the B2 Sensor is Reporting
It is best practice to confirm that the new B2 sensor is communicating with your program dashboard. If you do not have a login with Super Admin or Admin permissions, ask a colleague to perform this check. Choose the instructions below for your program dashboard.
Instructions for SmartSense
- Open a web browser and navigate to app.smartsense.co.
- Enter your credentials (username and password) then select LOG IN.
- Select ADMIN and then the UNASSIGNED SENSORS tab.
- Search for your B2 Sensor using the Sensor ID on the front of the sensor (search requires full sensor ID).
- When the B2 Sensor is communicating successfully, the Last Communication Date column should display a date and time. This confirms that your new B2 Sensor is communicating as expected.